Same subject, same board, slightly different problem. I did a 1/2 High Voltage kit from Bob, and all my connectors. Everything works except the relay circuit that turns on the flippers. That transistor works fine and I can short it to ground and the flippers then have power all the time, but I want to make it right.

Suggestions?
-Scott

Sorry, yes, already replaced it, didn't help.

Thanks! I'll try that.

This fixed it, thanks! Pin 8 at J4 on my board didn't have continuity. Step 1e on that trouble resolved it. I have that manual, but it must be a different revision, can you post a link to it?