Quoted from shirkle:I think I’ve tracked the Knocker and Flashers issue back to Q39 on the MPU. Can’t replace it until next week.
I’m still a little stuck on the Scoop. Based on the schematic, the flashers associated with the same transistor work. What could be the issue making the coil not work?
It is definitely getting power, and I replaced the diode on it.[quoted image]
I would check the diodes and resistors on the PPB board. That is where my issues were when I had some flashers not working while the corresponding coil was fine. I pulled the board and found loose solder joints.
https://pinside.com/pinball/forum/topic/jurassic-park-flash-lamp-issues#post-5067837