My g relay locks on and off hence bonus count is sluggish, what switch locks on g relay, it must get power from some where. Thanks peter

My g relay fires the same as mentioned by tuffano above, when the pauses occur during its cycle the g relay unlocks then locks again and continues to count,the red arrow above points to a switch which needs to be checked what is that suspect switch as i cant read the diagram,the g relay switches are good and it unlocks once power is turned off, if i manually hold g relay down it goes off the way it should like a machine gun. Thanks

When the bonus cycle resets to position one the two outside contacts close, r u saying make sure they remain closed and dont vibrate apart during the bonus countdown. Thanks

In the reset position my outside snow shoe starts on the second rivet with the yellow wire on completion of the bonus cycle the outside snow shoe finishes one step past the final rivet on the brown board, is this correct. Thanks

I asked the above question on the solar city thread and did not get a reply,in his first photo there is a drag mark past the final outside rivet, so i assume thats its resting place but i dont know for sure,i have just purchased my solar city and the outside snow shoe was alined to start on the first outside rivet not the second as pointed out,this was causing problems as starting on the first rivet looked normal without a diagram.