Hello,
I just picked up a cheap Taxi and I'm now ready to begin the "dump money into it until it's not cheap anymore" process.
I hooked all the cables back up (used the pic at IPDB to check where they went) and it played for about 2 minutes, then the main ball kickout began firing and I shut it off. Then I replaced the F4 fuse that it blew and turned it on again. This time it didn't do anything except I could see the RLY1 clear cube flickering on the bottom right board.
Now all I get when I start it up is the flickering noise. I tried to fire it up with everything to that board disconnected and I don't get the flickering noise anymore, and the red lights on the MPU are the same as when everything is plugged in - Lit +5, unlit Diagnostics, and a half lit Blanking.
Let me know where to start.
And thanks in advance for the assistance!
Jeremy