Currently, I think you have a blown fuse. Test out F101 and F102 on the power driver board.
(Topic ID: 218704)
You're currently viewing posts by Pinsider PinballManiac40.
Click here to go back to viewing the entire thread.
Quoted from toeskneez:Hey all. Fresh update on this issue.
I am happy to admit I am a nitwit!! I missed the little flipper circuit board on the right hand side of the back board, which holds 2 fuses. F901 and F902, which I think is the ones pinballmaniac40 may have meant instead of 101 and 102!!
Anyways, F901 was blown. Replaced it and all is good with the world again!! Thanks for all the help and advice!
I actually did mean F101 and F102 on the power driver board, but it does seem only the Main lower flippers are going through those. Sorry, I don't know TAF that well and didn't look it up in the manual.
Any case, good catch. Play ball !!!
Promoted items from Pinside Marketplace and Pinside Shops!
Rancho Cucamonga, CA
Vancouver, BC
Auckland, NZ
You're currently viewing posts by Pinsider PinballManiac40.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
