Hi all,

On my TAF, the chair kick out direction/strength often changes gradually over time. Sometimes, I can catch the ball by simply keeping the left flipper up. In other cases, it is very difficult to catch it, and sometimes, he kicks it directly into the drain hole (this behavior changes slowly over time). Sometimes it helps to slightly manipulate the mechanism under the playfield, to change its behavior slightly, but it's very difficult to control.

Did anyone of you experience similar problems?
Any ideas or hints to avoid this?

Many thanks

Thanks!

It seems I cannot fully tighten some of the screws, they keep rotating within the hole when I try to tighten them further

Ok, the screws are fixed, thanks!
However, the chair kickout is not consistent yet. I did notice that one of the 2 welds was loose.

Would a table clamp work (as a dirty fix) instead of finding a welder?

Kaiser_205027_Small_Table_Clamp_1233675936000_575004 (resized).jpg

ok, will do, thanks!