On my T3, the 2 mid field flashers were always off. I checked the bulbs and they were burned out. Since I didn’t have any replacement 12v leds, I put in the ones from the front two flashers. When I ran the flasher diagnostics, those two flashers were constantly on (which I’m guessing is why they burned out)

This machine is a HUO, but has a rottendog power supply and led ocd, but otherwise has no other mods. Any suggestions on what might cause these flashers to be always on?

Had a look and they all look at transistor q31 on the rottendog board and it looks ok.... is there a way to test it?

Also, does the led ocd board control flashers as well? Could it be a setting there?

Sorry for the noob questions.... I know very little about electronics.

It does not... I tested the others and they were all open, so I’m assuming that’s my problem....

Now I just need to find someone in the Pittsburgh area that can replace it for me.

Thanks for the quick responses everyone.

Thanks for the tip.... I’ll give him a shout.