I just got into this machine tonight and the right flipper will flip they stay in upright position. I can hand reset it. I looked at the coil and the wrapper is mostly off of it. I am thinking its a bad coil. Also the the ball pooper doesn't work and that coil looks toasty. The Dmd has vertical lines down it and I know it's not the Dmd. Even a new I does the same thing. I have not tried a different power control board. Last but not least it keeps blowing the solinod fuses 1-8 and 9-16 I think that is f104 and 105. Would the bad coils cause this?

I checked for continuity tip 102 has a short transistor. 20.. Can I meter out the rest of the coils to find out if any more are bad. That was the only bad transistor

Heck q20 is associated with the drop targets. Q82 is the ball popper.. It is a tip36c should I plan on just replacing that after I replace the coil?

After I remove a wire how should I go about checking them. Thanks for the baby steps

bump for LTG

The machine was really dirty. I am prolly gonna replace the flipper coil and plunger. The problems I am most worried about are on the board. The q20 transitor has a short in it. It is associated with solenod 28. Ball popper was 82 which is 1 of the large transistors