This is going to be fun and interesting. My only advice is dont be afraid to step away for even 2 weeks if you get frustrated for whatever reason. I am glad you are using the install kit. perfect job on the t nuts. it was those pop bumper nail screws that I started developing the kit. After I clear, its hard to get them to sit level, so the kit helps.
If you have installed t nuts without removing the clear, sometimes the teeth fold and you have to use a set screw to keep them from spinning, pulling them in with your screw gun. If you do wack the pf, dont do it on your roticery. put it on the bench with wood right under the spot you are going to hit to absorb the energy.
I think I mentioned before, but predrill, predrill predrill. I use the sizer and I use a drill bit one size smaller than whatever I am screwing.
The solvent for the glue is acetone if you spill any.
godspeed my friend