Ribbons all connected correctly?
—
Chris Hibler - CARGPB #31
Http://chrishiblerpinball.com/contact
http://www.PinWiki.com/ - The new place for pinball repair info
Quoted from ChrisHibler:Ribbons all connected correctly?
—
Chris Hibler - CARGPB #31
Http://chrishiblerpinball.com/contact
http://www.PinWiki.com/ - The new place for pinball repair info
Yes, I actually re-seated them. I am gonna order new ones.
All we can tell from the video is that the rotten dog MPU is booting properly. Let’s see where those ribbons are connected on the other boards.
—
Chris Hibler - CARGPB #31
Http://chrishiblerpinball.com/contact
http://www.PinWiki.com/ - The new place for pinball repair info
Quoted from ChrisHibler:All we can tell from the video is that the rotten dog MPU is booting properly. Let’s see where those ribbons are connected on the other boards.
—
Chris Hibler - CARGPB #31
Http://chrishiblerpinball.com/contact
http://www.PinWiki.com/ - The new place for pinball repair info
Ok, give me a few minutes
Thanks. Tough to tell if the one that goes from top right of MPU to lower connector on dot controller is correct.
Red stripes on MPU should be on left side.
Red stripes on Dot Controller should be on top side.
--
Chris Hibler - CARGPB #31
http://www.ChrisHiblerPinball.com/Contact ... for board repairs
http://www.PinWiki.com - The Place to go for Pinball Repair Info
Quoted from ChrisHibler:Thanks. Tough to tell if the one that goes from top right of MPU to lower connector on dot controller is correct.
Red stripes on MPU should be on left side.
Red stripes on Dot Controller should be on top side.
--
Chris Hibler - CARGPB #31
http://www.ChrisHiblerPinball.com/Contact ... for board repairs
http://www.PinWiki.com - The Place to go for Pinball Repair Info
I will double check tomorrow, when I have sunlight. I usually get these correct, but it does seem like I have one wrong here, or one is just bad. Thanks for the help Chris.
Lost my network connection so I haven't been reading many threads.
Check the ribbon cable at J603. The end that's plugged into your DMC is usually plugged into the DMD. The red stripe is on pin 1 but make sure the other end of the cable at the DMD is also correctly configured (red stripe at pin 1). When I look at your picture it looks "wrong" to me because the cable is usually "upside down".
Well I would say it’s booting fine. It’s probably stuck on screen factory adjustments. If the dmd is not letting you see anything turn the game on. Open the coin door. And hit the enter button. See if you get a heartbeat. Meaning inserts and everything else. Are you sure your dmd is not out gassed.
Also in the bottom of the cabinet you have a connector with 2 purple wires. Make sure that connector is connected. That’s power for the dmd also.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/t2-game-boots-gi-only?hl=tonyhoff1 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.