In the past 3 months, my Terminator 2 has developed an issue with what’s displayed on the DMD. Mostly it’s a line down the center of the DMD.
I’ve swapped out the DMD with another pin, but the issue stayed with T2, and T2’s DMD looked fine on the other pin. So the problem isn’t with the DMD.
I swapped the ribbon cable from the DMD Controller Board to the DMD with another pin, but this issue stayed with T2.
I’ve re-seated all the connectors in the back box, but the issue remains.
I completely rebuilt the high power section of the DMD Controller Board (all new components from Great Plains Electronics), cleaned up and reinstalled the board, but the problem is still there!
Any suggestions of where to look for other potential problems would be very appreciated!
Many thanks!
638036B0-C111-44CB-B541-F6C1807A4398 (resized).jpegC78C3391-6F0E-4DCB-9065-C48131A775A5 (resized).jpeg
09525A10-702A-443F-A33C-81A73134D420 (resized).jpeg7FD357BD-1220-4A66-9615-C4860E8C645C (resized).jpeg