Dan,
See follow up post I presented with more information here:
http://pinside.com/pinball/forum/topic/system-1-countdown-drop-target-reset-issues
Mike O.
Team-EM
You're currently viewing posts by Pinsider mikeo.
Click here to go back to viewing the entire thread.
Dan,
See follow up post I presented with more information here:
http://pinside.com/pinball/forum/topic/system-1-countdown-drop-target-reset-issues
Mike O.
Team-EM
You will need parts from this or other places:
https://www.greatplainselectronics.com/products.asp?cat=80
1. Get some of the -0134 and -0072 pins for most of the work for the board edge connectors. You will need both sizes to fit to the two different wire sizes you will encounter.
2. Get one of the -1919 crimpers
3. Get the -0016 pin extraction tool. You need this to remove the existing pins from the connectors and you reuse the connector bodies so don't destroy them getting the pins out.
4. If you plan to repin the power supply connectors I would get some of the -0113 and -0125 pins also. The originals are the same as the -0134 and -0072 pins above but the -0113/-0125 trifurcon pins are more reliable. If this game is all you have to address the -0134/-0072 pins could do you for all the boards.
You're currently viewing posts by Pinsider mikeo.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/system-one-problems-with-janin-board-or-not?tu=mikeo and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.