I have an Alien Star I'm trying to get going.
I have a laundry list of adjustments that I still need to do.
1) Rebuild of Power Supply.
2) Grounding of boards (CPU, Power, Driver)

My question has to do with the 12V supply from the bottom board.
When I measure the voltage at the Bridge Rectifier I get 16VDC.
Replaced Bridge and had no change.
Transformer is giving me 12.5 VAC correctly.
I currently have a 10000 uF 25 V capacitor installed for the 6800 uF 25 V.
My other currents are 60 VDC (measured 65.7 VDC), 42 VDC (46 VDC).
Is this a standard voltage output or is it way out of tolerance?
If it is way out of tolerance where should I begin my investigation?
Thanks
Jim

Thanks.
I kinda figured that there might be some overage for the entire system when it's loaded.

I've got another question regarding the 8.2 Zener Diode at CR7 on the power Supply board.
Pinwiki suggest a 8.2 V 1 W as a replacement where as the schematics have a 8.2V 2 W.
I thought it would be safer to go up in wattage not down?