Put some incandescents in there to test.
--
Chris Hibler - CARGPB #31
http://www.Team-EM.com
http://webpages.charter.net/chibler/Pinball/index.htm
http://www.PinWiki.com - The Place to go for Pinball Repair Info
You're currently viewing posts by Pinsider chrishibler.
Click here to go back to viewing the entire thread.
Put some incandescents in there to test.
--
Chris Hibler - CARGPB #31
http://www.Team-EM.com
http://webpages.charter.net/chibler/Pinball/index.htm
http://www.PinWiki.com - The Place to go for Pinball Repair Info
I like the precision and uniformity of those jumpers Pat. Quality.
--
Chris Hibler - CARGPB #31
http://www.Team-EM.com
http://webpages.charter.net/chibler/Pinball/index.htm
http://www.PinWiki.com - The new place for pinball repair info
Quoted from Patofnaud:The 'gap' left by the resistor is a bit large so a 0 ohm would/could look weak and funny. Purely aesthetics.
And, zero ohm resistors don't have insulated leads. In this case it might not matter, but generally, long, bare leads are not a good thing.
--
Chris Hibler - CARGPB #31
http://www.Team-EM.com
http://webpages.charter.net/chibler/Pinball/index.htm
http://www.PinWiki.com - The Place to go for Pinball Repair Info
You're currently viewing posts by Pinsider chrishibler.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/system-11bk2k-mosfet-mod?tu=chrishibler and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.