can someone post the link for this mod?
You're currently viewing posts by Pinsider beaky.
Click here to go back to viewing the entire thread.
do they make LED ghosting any worse? or is it the same?
is there any reason why a 0 ohm resistor can't be used in place of the wire jumper (like when removing the diodes from a WPC95 G.I. section on the power driver board, 0 ohm resistors were used in factory modded boards)
thanks, i just find using wires look like the board has been hacked, that's just my opinion, i always try and make my repairs look as neat as possible, i'm not saying there is anything wrong with the photo shown with the wires above, they have been done neatly.
Any time i have to use a wire on a board for a jumper i use a dark green wire close as i can get to the color of the board, they look less out of place
You're currently viewing posts by Pinsider beaky.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/system-11bk2k-mosfet-mod?tu=beaky and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.