pacmanretro I recently got an 11A board on eBay for $75 shipped. Haven't dug into it to see what repairs are necessary yet though.
You're currently viewing posts by Pinsider ChrisPINk25.
Click here to go back to viewing the entire thread.
pacmanretro I recently got an 11A board on eBay for $75 shipped. Haven't dug into it to see what repairs are necessary yet though.
Volts don't matter on capacitors as long as UF matches and you are meeting the minimum volt amount. Did you install any backwards or in the wrong spots?
What did you use as ground when taking the measurements? A bad connection in the backbox to ground could result in weird readings.
Quoted from mystman12:Correcting the fuses on my new Taxi, and I'm not sure which fuse to put in F4 of the AUX driver. Manual says 2A, guide in the cabinet says 2.5A. Which is correct?
I'd lean towards lower, so 2A
Quoted from Pinash:Is this side rail supposed to attach with screws? I’m rebuilding the entire area that the head sits on and these screws are an eyesore
[quoted image]
Looks like a WPC rail.
Quoted from Blackbeard:Good way to clean contacts is to squeeze em between a business card and slide the card back n forth a little.
Glad you figured it out.
Or as vid1900 would say, use a crisp 100 dollar bill to clean those contacts!
Quoted from Manimal:Question for the circuitry gurus:
Continuing on this resto, I'm going to re-pin all of my Diner Sys 11C boards, and I figure I might as well replace C24,C26,C29 at the same time. Book calls for 100ufd 25V. Looking at the caps on the board, they show 100uf but 35wv (working voltage). Will either of the 25V 100uf caps I previously sourced from Mouser work as a replacement? Or do I need a higher voltage cap?. New 25V caps are a bit smaller and got me to thinking I was under-sizing the replacement.. Thanks
[quoted image][quoted image]
25v will work. Going higher is always ok, not lower.
Quoted from sullivcd40:Is there a chart for coil resistances somewhere? I can't find what they should be in my PZ manual.
Will this help?
https://flippers.com/coil-resistance.html
You're currently viewing posts by Pinsider ChrisPINk25.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/system-11-club?tu=ChrisPINk25 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.