(Topic ID: 11919)

Supercharger not registering.


By sixsixtie

7 years ago



Topic Stats

  • 5 posts
  • 3 Pinsiders participating
  • Latest reply 7 years ago by sixsixtie
  • No one calls this topic a favorite

You

Linked Games

You're currently viewing posts by Pinsider sixsixtie.
Click here to go back to viewing the entire thread.

#1 7 years ago

The supercharger on my getaway is not working. The ball if hard enough will go up and around and a million will register per shot but it won't be the right animation on the DMD and it is extremely slow and weak going around. It will not register at all during supercharger mania after fourth or it won't register the start of Redline mania.

The test said that the OPTO 1 switch was stuck open and I replaced both the leds today and that seemed to have fixed it in the test. However the main problem is still the same.

I also replaced f103 fuse that looked burnt out but Im not sure if I did it with the right fuse. It was a 3amp 250 volt but it was from a automotive store and looks a little different than the fuse I took out. Are there different types?

What should I check next? This is my first machine and I'm learning as I go.

Ty

#4 7 years ago

Read your thread hypertrev sounds similar but a bit different.

#5 7 years ago

Hrmmmm pulled the supercharger board and it seems like all the transistors are good. The only resistor that seems bad is r6 but it's so tiny. Could that really be the root of the problem or is it probably just one in a line of problems?

Promoted items from the Pinside Marketplace
$ 399.95
Lighting - Led
Pin Stadium Pinball LEDs

You're currently viewing posts by Pinsider sixsixtie.
Click here to go back to viewing the entire thread.

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside