Star Trek: The Next Generation
Williams, 1993You're currently viewing posts by Pinsider fxdwgmb.
Click here to go back to viewing the entire thread.
You only need to remove the two wire ramps, there not much in the middle of the playfield. Use freeze spray... You can use a standard air spray, just turn the can upsidedown when spraying. Additionally you can get freeze spray from www.littleshopofgames.com.
Good Luck.
I damaged a few inserts when I removed my mylar. I wet sanded with a 600 grit paper to remove the razor blade damage. Tape playfield around the insert to prevent damaging any more of the paint around the insert.
You might want to try and make a new insert out of transparency film rather than the replacement sticker. You can reverse print on the bottom of the film to prevent damage to the artwork once installed. The hardest part is finding the correct font to match.
You're currently viewing posts by Pinsider fxdwgmb.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/sttng-playfield-mylar-removal?tu=fxdwgmb and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Winston-salem, NC