Needing some tech help. Here’s what happened. I hooked up a pinballbulb led light strip kit to my STTNG and when I turned game on the strip that mounts under the DMD wasn’t working. When I grabbed the two wires that connect to the strip (while game was on) I saw it sparking. The ground wire had come loose from the led strip. Right after I saw the spark at the strip the game began auto ejecting the three balls under the playfield. I immediately turned the pin off and removed the led strips including its connection to power board at J116. When I turned pin back on it did the following: it auto sent three balls back up under playfield (as I would expect) then after a few seconds the gun kicker solenoids fired and pretty much immediately after the three balls auto ejected from the left popper and drained back to ball trough. Then when I hit start button the only thing that happens is left and right gun poppers rotate firing, but otherwise all six balls just remain sitting in trough. Any ideas? Thanks