Are those all on the same circuit board? If so, reflow solder at the base of the header pins. If that doesn't do it, reflow and add a tiny bit of solder to the socket pads.
Yes all on Same circuit board but different pars of it I guess I need to take it out again and really check those three traces, the biggest header is very hard to get on and off so I'm guessing it's from that and that had a lot of red wires if I remember right which most of the lamps are connected to from that board, so close to being done with my LEDs the way I want it
And while I have this thing out any tips to make the connector not as tight which Im guessing increases chances of broken solder issues
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/sttng-few-lights-out-around-mission-and-targets and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.