Help! I disassembled my Striker Xtreme playfield for cleaning, didn't take enough pictures or measurements, and can't figure out how to put it back together.
Page 58 of the manual shows:
No Metal Spacer Qty SPI Part No
2 3/8" 2 254-5008-12
3 1/2" 8 254-5008-03
4A 5/8" 1 254-5008-02
4B 5/8"(Male) 2 254-5024-02
5 3/4" 4 254-5008-04
6A 7/8" 1 254-5008-05
6B 7/8" (Male) 2 254-5024-05
9 1-1/4" 1 254-5008-11
14 1-3/4" 3 254-5008-10
17 2-1/8" 1 254-5008-32
24 3" 2 254-5008-14
27 3-1/2" 3 254-5008-27
29 3-3/4" 3 254-5008-36
and there are 3 areas that I cannot figure out which lengths of post are used to hold the plastics up:
- Left side (-7, -13, -14, -30)
- Center Ramp (-20)
- Left Side of Ramp (-21, -31)
I attached the only photos that I have, but I can't figure this out with deduction or test fitting. I didn't realize that this machine had so many posts that vary by only 1/8". And plastic -31 looks like a design mistake.
I found another thread (https://pinside.com/pinball/forum/topic/striker-xtreme-playfield-pics-needed) where SilverballSleuth asked a similar question but I still cannot tell from the photos
I'd be eternally grateful if somebody would be willing to pull out some calipers, loosen a few plastics, measure the posts on their machine, and tell me which lengths go in each location.
striker (resized).png