Quoted from trilogybeer:If a component from the UV kit was not threaded and it came without thread cutting screws, then yes either the item should have been threaded or the kit should have included thread cutting screws. I was just trying to make people aware of the fact that some items from Stern will come without threads and thread cutting screws will be needed. Flipper base plates and shooter housings are two examples of Stern items that require thread cutting screws.
When all of my slots came threaded but one of them, I don’t think that was Sterns intent. I was able to find the correct tap size by gauging the other threaded slots. It’s bad quality control by Stern.
This morning I went to install my shaker…… they installed the braided ground right over top of the right side holes….. and the Stern OEM shaker cover is squeezed in so tight because they didn’t box out the coindoor symmetrical with the 1/2” wood trim. Plus I’m missing the little bronze/copper playfield guides on inside of cabinet…… that’s all I noticed …… so far