Would i need to get longer leg bolts to work with the added leg bolt plates ?
You're currently viewing posts by Pinsider golfingdad1.
Click here to go back to viewing the entire thread.
I have picked up the HD brackets and welded up the corner gap.
What size screws are you guys using to install?
Half inch looks small and 3/4" looks like it maybe to long .
Quoted from PinMonk:With the B/W braces, 3/4" with a couple washers worked out well. Test it over the top side to see how close to the outer edge it will come if you have the brace+washers.
I don't have the BW braces. I have the HD L cabinet corner brackets.
Any one ?
Quoted from Rock914:I am not a fan of the L-bracket myself but If the L-bracket is 1/16" and your cabinet measures 11/16" that gives you 3/4". I would not use anything larger than 5/8 of an inch with 1 small washer. 1/2" if you are not using a washer.
Don't listen to me or anyone else on here. Measure yourself and determine what is needed. I would hate to see anyone mess up their cab because they used a screw that was too large.
Good luck! At least with the L-Brackets you may not need to move the ground braid.
Thanks , it's more than just an L bracket , it's a corner brace for cabinets , that I have welded together at the corner . 20170503_161301 (resized).jpg
These should work great .
You're currently viewing posts by Pinsider golfingdad1.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/sterns-new-cabinets?tu=golfingdad1 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.