Quoted from DG_Amuse:

My machine was exhibiting the Demogorgon shot issue that has been talked about here. I took some slow motion videos with my phone and it turned out the ball was coming in consistently low and then bouncing around. To fix this I placed some shims (a pop bumper fiber yolk broke in half) under each of the assembly’s feet. See pics for reference. This effectively steepened the ramp, which worked like a charm on my machine. I did have to relocate the ramp-down-position switch, because otherwise the ramp would stop about a 1/4” above the playfield surface. I hit four consecutive Demogorgon shots in row after the adjustment. Hope this helps someone if they’re experiencing similar issues. Cheers.[quoted image][quoted image]

Quoted from DG_Amuse:

My machine was exhibiting the Demogorgon shot issue that has been talked about here. I took some slow motion videos with my phone and it turned out the ball was coming in consistently low and then bouncing around. To fix this I placed some shims (a pop bumper fiber yolk broke in half) under each of the assembly’s feet. See pics for reference. This effectively steepened the ramp, which worked like a charm on my machine. I did have to relocate the ramp-down-position switch, because otherwise the ramp would stop about a 1/4” above the playfield surface. I hit four consecutive Demogorgon shots in row after the adjustment. Hope this helps someone if they’re experiencing similar issues. Cheers.[quoted image][quoted image]

Quoted from Whysnow:

thanks very much for sharing.
I need to get a buddy and glass off along with slo-mo camera running to figure out if ours is going high or low and then tweak.
Based on regular vision, I think ours is going high. I am not sure how to make that adjustment easily. May need to fabricate a shorter bracket? or would be better to raise the sculpture with shims likely.