Stars
Stern Electronics, 1978You're currently viewing posts by Pinsider Neal_W.
Click here to go back to viewing the entire thread.
Everything is working normal, but noticed my tilt bob has stopped working.
All the wires are secure at the tilt bob and tilt roller. Diode located by the tilt roller shows open one way and 555 the other way on my meter using diode check.
The wires ring out OK from the bob/roller to CPU J3 pin 15 and pin 2 like the drawing shows.
I have no experience with the Alltek board. What next?
tilt bob (resized).jpg
tilt bob wiring (resized).jpg
alltek (resized).jpg
Did some more checking, had J3 off/on a bunch of times. Confirmed pins 2 and 15 measured open to ground. Put a jumper clip across the tilt bob and measured across 15 and 2, and as expected I could see the 555 from the diode and open with the jumper removed.
Played one more game, and now the tilt is working again!?! 
Quoted from Knxwledge:Maybe a flaky J3 connector?
Not expecting a low power connector to act up, buy maybe. At least it seems it's not a bad board, since it is working again.
Quoted from phishrace:Tilt bob looks grungy. Lightly sand that and the ring.
Agree shiny is best, but this thing was 100% dead, even grinding the bob against the ring did nothing.
You're currently viewing posts by Pinsider Neal_W.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/stern-stars-tilt-bob-stopped-working-?tu=Neal_W and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
St. Louis, MO