Straight out of the box my SMVE needed the trough switches adjusted. The arms were all bent upwards so far that they would make the ball(s) roll back up the trough and the switches wouldn't register.
Caused all kinds of issues with mulitiball and the game launching balls when it shouldnt etc.
Quick fix to adjust the switch arms and all was well.
But i did notice that the tiny black 3/16 hex head screws that hold the switches in place wouldn't really tighten down well. Its like the back side of the ball trough that they scew into was stipped out. I tightened them down as much as possible and then never thought about it again.
Today I found two of the screws and the little metal spacer for the plate on the front side of the switches had fallen down into the cabinet. many of the other screws were loose. Thing is that I can't get them to tighten down.
Any ideas on how to fix? Should I contact my distro to get a new trough? or is there a simple thing I can do to the trough frame to make the screws tighten down?
I've never had any issues with my other two stern games. I checked and the screws are tight as day 1.
suggestions?