Hi All
I have just replaced the rectifier board on my Stern Wild Fyre but having some voltage issues. Obviously all the header pins are new as are the molex connectors and plugs.
I plugged in J2 just to check voltages however I am missing a lot of voltages as you can see below. Biggest issue I think is that TP2 is only 144v and it should be 230v.
I assume it must be the transformer as I have triple checked that all the wires are in correct positions.
Any help or advice would be appreciated and also how to check the transformer directly.
J1-1... 0v should be 7.3v
J1-2... 0v should be 7.3v
J1-3--
J1-4--
J1-5... 0v should be 7.3v
J1-6... 43.4 should be 43v
J1-7... 5.9v should be 5.4v
J1-8... 0v should be 7.3v
J1-9... 5.8V (NOT USED)
J2-1... 6.6V should be 7.3v
J2-2... 43.4V should be 43v
J2-5... 0V should be 7.3v
J3-1... 0v should be 7.3v
J3-2... 0v should be 7.3v
J3-3... 0v should be 5.4v
J3-4... 0v should be 5.4v
J3-5... 159v should be 230v
J3-6... 5.8v should be 5.4v
J3-7---
J3-8... 10.8v should be 11.9v
J3-9... 43.1v should be 43v
J3-10... 6.5v should be 7.3v
J3-11... 6.5v should be 7.3v
J3-12... 43.3 should be 43v
J3-13... 43.2 should be 43v
J3-14... 0v should be 5.4v
J3-15... 0v should be 11.9v
J3-16... 0v should be 230v
J3-17... 0v should be 11.9v
J3-18... 0v should be 230v
J3-19... 0v should be 43v
J3-20... 0v should be 43v
TP1... 5.8V should be 5.4v
TP2... 144.9V should be 230v
TP3... 10.8V should be 11.3v
TP4... 6.5V should be 7.3v
TP5... 43V should be 43