Need some help...
Have a friend with a Stern Monopoly that won't hold settings after its turned off.
Keeps going back to insert coins and 3 balls. tried new batteries with the same results.
Any advise on where to look?
Thanks
You're currently viewing posts by Pinsider dug.
Click here to go back to viewing the entire thread.
Need some help...
Have a friend with a Stern Monopoly that won't hold settings after its turned off.
Keeps going back to insert coins and 3 balls. tried new batteries with the same results.
Any advise on where to look?
Thanks
Quoted from Pin_Guy:There is not a lot that can go wrong here, either you are missing battery voltage to pins 20 and/or 28 of the RAM, or you have a bad RAM. The voltages are very easy to check and I suspect if they are missing that at some point in this games past the batteries may have leaked and eroded the board connections at either the battery holder or at D201.
Since this is a Whitestar game with socketed RAM at U212 the easiest solution is to drop in NVRAM and get rid of the batteries.[quoted image]
NVRAM worked!
Thanks again
You're currently viewing posts by Pinsider dug.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/stern-monopoly-not-holding-settings?tu=dug and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.