So I had the ball getting stuck in the Demon head and not ejecting. I ended up calling Stern and working with Chas to troubleshoot the issue and I ended up needing a new node board 10 to replace. So 3 days later I get the new board and get everything connected properly and then I boot it up. It then starts to do a node board update and then fails on node board 8. While I'm waiting on Stern to respond to my email any ideas as to what else I may be able to do to get this working, if at all possible?

Thanks in advance,
Jeff

20180329_164737 (resized).jpg

Turns out they don't set the dip switch settings correctly before sending out. After I did that everything booted up normal. However... first ball into the demon head and it gets stuck again! No idea what is going on here. Hopefully Chas can figure it out.

Next up for troubleshooting is I am having mailed to me a "snubber bracket" as mine doesn't have. They were later added to stop ball traps during multi-ball. I'm still not sure that this will be the fix, but I'm really hoping it is.