Instead of spending the $200.00, made my own out of a wooden egg and a little paint, blank shooter rod, and coated 3 times in 2 part epoxy....smooth as glass and has a nice weight and feel to it. Best thing is when I get my game and if I don't like it I can remove it....cost less than $25.00 to make.

IMG_20220312_223606 (resized).jpg

I would recommend 2 part epoxy. I did that with the egg I made myself and it's smooth as glass.

Don't think I would spray it with anything. 2pac would be too expensive and a waste.

IMG_20220312_223330 (resized).jpg

IMG_20220312_223606 (resized).jpg

Looking for suggestions on powering mods for Godzilla. I've seen several solutions but being my first nib game I'm not wanting to damage any of the node boards. List of led mods I'll be running. Godzilla with lighted atomic breath, mechzilla with led lighted eyes, lermods Tesla mod, flaming frames, home made topper with burning building made with the insides of a flame bulb for home use lol. 20 inch led strip from comet pinball and two blue spotlights magnum bulbs. All except the flaming frames run off of standard 5-6.3 volts my worry is tying everything into the GI might be too much of a strain and damage something.

Should I go with the pinball life spike 2 separate power supply?

Thanks!

Hopefully so.....I had just read in one of the older posts that stern likes to run lean on their power distribution without a lot of extra left over for much of a draw....Leds shouldnt draw that much but wasnt sure If most of these mods tied into just the GI would be too much...I would rather buy a 50.00 separate power supply then be risking it. I never worried about these things with the old williams/bally or my spooky machines. No node boards to worry about

Fixing to recieve my NIB GZ. I need some feedback. How many of you installed a playfield protector on your game? This will be a home use game only.

Thanks for the feedback ☺️

Hey Chip, I'm still waiting on mine also, ordered February 4th checked on them through email a month later and got the chastised response for even checking. I haven't emailed again because he has a 3 emails your order is cancelled policy. Quickly coming up on 4 months of waiting. If I didn't think the mod was worth it I would have cancelled a while ago since I've never had a issue getting updates for mods from anyone else on pinside. Maybe if they are a pain to make and take time maybe he should offer a assemble yourself kit with all parts needed to reduce the wait time.

Yeah not a good idea. I've been waiting coming on 4 months and have already been chastised for not following the rules on his site.