GOTG banner down. Godzilla Banner up

B977BA2F-A263-4709-924E-298664F176CD (resized).jpeg

Colin makes all that stuff.

The guy who posted the pictures!

He does some great stuff.

MEchagodzilla ball hang up I get quite a lot- thinking of putting a “dot” on that area.

Never had the bridge Hang up yet.

Jeffswack
Please let us know what this was.. very interested in finding out

where’s the GZ topper pics.. egarly awaiting those

Go into switch matrix and look for a Stuck switch

Put my GZ LE on and whilst playing noticed the building was catching on something when raising.

Turns out it was the decal on the bottom section of the building. When it raises the decal was catching on the bridge mech, or on the edge of the hole that it lowers into.

On rising back up the decal was peeling and taking and snagged on the bridge mech.. peeling the left side and then going along the top of the entrance.

Have had to cut the decal on the left. Have emailed Stern to see if I can get a replacement decal for it.

18FF56DB-AE24-497F-9807-C0A6B9C2A616 (resized).jpeg

959128D4-7637-4ACA-9697-D9834ECCD3F2 (resized).jpeg

The bottom of the building looks to be attached by 4 small screws.. anyone know how the building goes together do I have to remove entire building mech to fix this..

Or will the plate slide out?

Is there a lot
Of movement in peoples building? The building mech underneath is still solid, but the building does have a few mm movement left right, front & back..

Hey All.
Having issues with building alignment.
*building decal was catching on clear plastic in front of building.
*Tightened nuts on mech under playfield, which solved the rubbing of decal, but raised building so entrance has a lip.
*tried to adjust the building by hand.. stupid, made it worse.
*found out about BIAS in options- it’s now at 300 (should be around 150) but it works.

Would like to get it back to 150.. but I reckon it involves the switches either top or bottom and messing about by hand with the drive shaft.

Have tried several times to position the building a bit below the playfield, and then lowering to back to 150. (Lower the BIAS the building goes UP)

But when testing the building goes back to the lip, and I have to adjust to 300 again.

The building goes up, hits the top switch then stops, goes down, and then back up.. do I need to bend switch arm on top, to activate quicker and then the building will stop shorter.

Hope this makes sense

Could I ask a few pinsiders to post what the Bias is on their buildings..

Also the top 2 nut & bolts on the mech underneath