The glow would indicate you have HV to the board. I would really scrutinize the solder joints on the header pins before you go any further.
Reflow any pins that are questionable
You're currently viewing posts by Pinsider Cheddar.
Click here to go back to viewing the entire thread.
The glow would indicate you have HV to the board. I would really scrutinize the solder joints on the header pins before you go any further.
Reflow any pins that are questionable
So this is the reference for display repair. http://stevekulpa.net/pinball/bally_disp6r.htm
Test the 100k ohm resistors and make sure they're good. They are underrated for this job and may be open.
It's also time for you to bust out a schematic. Stern's can be numbers different so find a stern schematic of you don't already have one.
At this point once you can verify you have power to the test points (and that it is high enough ~190VDC) then you need to look at the digit enable transistors and the decoder.
You're currently viewing posts by Pinsider Cheddar.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/stern-7digit-displays-blank?tu=Cheddar and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.