Quoted from dkpinball:
In a week or so I'll be putting up a feeler to gauge interest to see if I can get enough people looking for cards to cover order minimums.

Ok. If I can come up with one second-hand, can you offer support for setting it up?

I think you had some code written for slow, pulsing, and fast motor use. Also, what motor did you use? Did it supply the 12v for the motor from the Pig 2, or was the Pig 2 sending to a 'control' input on the motor/motor board?

I'm looking for shaker motor install of F14. We had discussed it briefly over email, but that was a while and ago and I hadn't heard back from you.

Would appreciate any info.

#10 8 years ago

JDB

kilmarnock1350

Pinside member

Pensacola, FL

9y 34,800 398 25

Quoted from dkpinball:
I pulled 12v off the games power supply (Using a power tap). The shaker motor just plugs into the PIG 2.

Do you have the data for the settings you used? I seem to remember a low "pulsing" vibration, and a couple others that gave it variety.

Please let me know what you can dig up. I'd like to use yours as a starting point to then fine tune for my application.

Thanks!

You're currently viewing posts by Pinsider kilmarnock1350.
Click here to go back to viewing the entire thread.

Reply

Wanna join the discussion? Please sign in to reply to this topic.

Hey there! Welcome to Pinside!

Donate to Pinside

Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!

This page was printed from https://pinside.com/pinball/forum/topic/status-of-dk-pinballpigpig-2?tu=kilmarnock1350 and we tried optimising it for printing. Some page elements may have been deliberately hidden.

Scan the QR code on the left to jump to the URL this document was printed from.