Ribbon cable from CPU to Aux board is twisted.
Red tracer should be up on J204 CPU board side (this is correct in the pictures) and to the left on the Aux board (in the pictures it is to the right).
(Topic ID: 187200)
Linked Games
Star Trek: The Next Generation
Williams, 1993
Topic Gallery
You're currently viewing posts by Pinsider schwaggs.
Click here to go back to viewing the entire thread.
Quoted from Pin_Guy:Good catch, but since its twisted on both sides it will work fine like that
Thats not what I see, I see the cable twisted only on one end.
Pin 1 is at the top of the CPU board connector which is where the red tracer is on the ribbon cable (correct).
Pin 1 is on the left of the aux board connector and the red tracer is on the right (backwards). OP - try swapping the orientation of the ribbon cable connector on the aux board end of the ribbon cable.
Quoted from Pin_Guy:Ah, I see where the confusion is; pin one is actually on the bottom side of the CPU connector, not the top.
Thanks for the picture.... yet another error in the manual. The manual shows pin 1 at the top.
Promoted items from Pinside Marketplace and Pinside Shops!
Mechanicsville, VA
You're currently viewing posts by Pinsider schwaggs.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
