Picked up a Star Trek Pro for a friend of mine and I'm almost done with it but I'm noticing that some of the inserts are ghosting. I thought that was eliminated in the newer games. It has coin taker bulbs in it so I don't expect it to ghost. Could that be a board issue or a bulb issue? Appreciate any help thanks!

Anybody?

Yes it does & it looks intact. I'll try to reseat them again tomorrow. I had the board out earlier for a flipper that was staying energize. I did look at that wire when I was putting the board back in.

Everything looks fine to me. Am I missing something here?

1457992196183_(resized).jpg

Is that correct? Still getting some ghosting but not quite as bad.

20160314_185952_(resized).jpg

Thanks for the help! It's ghosting a little bit but I'm just going to live with it at this point

Where is that? I scrolled through most of the menus & didn't see that..