yeah well that may be me.

I just plugged my flash drive in and it said there was nothing there

I unzipped it before putting it in ( I think)

It says:

update not found

should I delete the files and try to download from the website again?

I don't think I unzipped it before downloading it to the flash drive-going to try that and report back

yeah obviously I am a fucking idiot-I do not know how to extract or unzip this file

well I downloaded winzip-and somehow lucked into saving it as a zip file. It is downloading to my pin right now-likely I will be back with the problems with my download shortly

well 1.4 is now downloaded thanks for the support.

Now I just have my standard problem that I've had from day one-

machine says locating balls, and doesn't even start a game 1/2 of the time-everything checks out in switch test mode, but still my problem exists.

no response from stern yet concerning my issue

THanks for the ideas for the opto board. I went in and if memory serves me correctly the molex connector didn't come loose, but it appears to have unseated 1/8". Certainly not enough to lose connection you wouldn't think, but who knows. I hate any connnector where you slide/pull the wire between the metal to gain connection. I tweaked/yanked/pulled the wires into that connector and tried to seat that molex very firmly, been good since. At this point I'm working on the premise it was a connection issue. I may go in there if it happens again, and actually strip the wires prior to seating them in the molex and reflow the solder at that point. Solder looks good though. I've done a ton of soldering rebuilding arcade monitors, power supplies, opto boards in the past.

thanks once again for the insight guys, it definitely helps.

I'm a little mad my 93,000,000 point score got deleted with teh update, lol.
After what seemed like 50-10,000,000 point games on the new update, I finally got my na me on the board with 40million.