You're currently viewing posts by Pinsider pinmonk.
Click here to go back to viewing the entire thread.
Undercab lighting is a LOT of LEDs, so the biggest concern would be that you're not pulling more than 2A from CN11 if you add another thing (the flipper lights). I'd move the undercab lights to the CN6 12v connector on the power distribution board in the backbox, and use CN11 just for the flipper lights.
Quoted from Meegis:Will take a look there, but if I remember, isn't it a different connector there?
Yeah, it's a different type connector. You need to put a different end on it, but you can get one of the pressure fit ones, so you just push the wires on and it cuts into the wire's insulation to attach the connector. You could get just the connector from Mouser or Digikey, or buy Pinball life's adapter and pull off the connector to use.
Quoted from Meegis:This is a different type of connector, but great to know it's available.
But the other end of it (the one that attaches to the power distribution board) is the type you need, then you can just press on the two wires for what you want to connect onto it.
You're currently viewing posts by Pinsider pinmonk.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/splitter-for-cn11-on-cabinet-board?tu=pinmonk and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
