Someone asked me how I'd make the head components disconnect from the cabinet components.... My plan is to run my wiring off the terminal blocks at the bottom of the main panel to multiple circular connectors. This will allow for an easy disconnect. For the network cables, I built a box to easily connect and disconnect the two cables. AC power will be on it's own connector along with the DC power (12/5vdc). 48volt power supply will be located in the main cabinet body.
Total wire count from head to cabinet (SO FAR):
CONNECTOR #1:
1 - 120 VAC
2 - Neutral
3 - GND
CONNECTOR #2:
1 - RGB CH1 DIGITAL OUT
2 - RGB CH2 DIGITAL OUT
3 - RGB CH3 DIGITAL OUT
4 - 5VDC
5 - 5VDC
6 - 0VDC
7 - 0VDC
CABLES:
9 - NETWORK CABLE OUT
10 - NETWORK CABLE IN