The spring loaded solder suckers work fine for the occasional small job. I have an 808, and I sometimes still use a cheap solder sucker.
(Topic ID: 78163)
You're currently viewing posts by Pinsider gweempose.
Click here to go back to viewing the entire thread.
Quoted from Pinfidel:Let me ask you all this though...If I want to RE-flow solder over all the older solder, can I just go right over it or would you need to remove the old solder and then re-flow the new?
I am hardly an expert on the subject, but I generally heat up the old solder, and then add a little fresh solder to the mix.
You're currently viewing posts by Pinsider gweempose.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
