Yeah, I'm starting at the worst part on the bottom and working my way north on this board, U8 wasn't nearly as bad but replaced that too after an acid bath. The game was in a garage for 12 years when I got it - some lights worked but it never actually played.
This is my first serious foray into board repair, did all the recommended cap and header pin repairs and ground mods on the driver board and that went fine (Thanks for the guides Vid). Battery corrosion is another animal though, I'm finding, some of the traces and pads are lifting on the first header I'm trying to replace. And, I can SEE surface corrosion on lots of things but does that really mean they are bad...i will replace that CR44 diode, thanks. I hate to surrender and just get an Alltek board, I'd like the satisfaction of bringing this back from the dead. I'm going to keep at it.