Depending on the connector housings you purchased, you may not want trifurcon pins. If you look up the Molex connector part number it should tell you what series of Molex terminals/pins it works with. I'm speaking from experience Early on I made the mistake of using trifurcon .156 pins in a Molex housing they weren't made for and they fit SUPER TIGHT onto the header pins on a Williams Sys7 board. They did not go on easily and definitely did not come off without a fight! And that was with the board out of the machine (at the bench) where I had access from all angles.
You'll probably be fine with the trifurcon, but just so you know there are .156 connector housings that won't work with them properly.
---
http://www.pinitech.com - "Pinball Inspired Technology"
Kits, upgrades and test equipment for pinball machines