Things had been fine, then during s game smoke cane up from under the pf. I took some photos. I think the immediate
Is the pop bumper coil
Bc it’s locked up.. before I just replace what else usually needs replacing as well?
I also noticed this small light board looks cooked. The lights work so I would just replace the resistor ?
Thanks

5770E457-291A-40DE-BCFC-8D171DAD136A (resized).jpeg

77B2928D-8611-479F-B414-E41A52A12840 (resized).jpeg

Could this have been the issue ? The metal yoke was split

image (resized).jpg

The switch was fine. But the plunger was stuck in the coil

Firepower

The other pops were functioning

What should I look for that would cause the coil to burn up?

And is there a name for the light board?
I am sure that should be replace as well

Thanks. I will read through

Just trying to figure if that coil
Could have burnt bc its 30 year old, or if one of the resistors on the switch are suspect as well..

Finally got a chance to work on this
So I checked the tips and the ones associated with the pop had the same readings as the neighbors
I replaced all the components associated with the pop switch.
When I tested them the only one that was bad was the diode on the coil itself..
Could that have caused it to lock. Want to be sure before power up

Thanks for reply. I rechecked the wires and powered it on. Everyone thing worked. It had to be the bad coil diode,
But now the pop switch has all new components. Should be set for a while