Looking for a players condition Slugfest. Located in NJ. Prefer pickup
Thanks
You're currently viewing posts by Pinsider cmjb13.
Click here to go back to viewing the entire thread.
Quoted from hawkeyexx:Look in the manual and loosen the adjustment screw for that wheel and you should be able to put on new o-rings on the wheel.
I removed the screw on the wheel, but it wouldn’t budge. I just removed the screws on the metal plate attached to it and was able to access it.
I just had NVRAM and reset the machine to factory defaults.
I set the innings
Quoted from hawkeyexx:If you have a manual there are instructions on adjusting it. If not I will post it from my maual.....
I know there are 4 screws to loosen and move the roller, but I’m wondering how much gap should there be?
Quoted from hawkeyexx:Make sure you have new O rings on roller. Have one card ready in the dispenser and set the roller snug the card.
As you can see 2 of the 4 are missing and the 2 are original. 1 broke off yesterday as it was very brittle.
I’ve bought replacements and will install them later today and report back.
Quoted from Cmjb13:As you can see 2 of the 4 are missing and the 2 are original. 1 broke off yesterday as it was very brittle.
I’ve bought replacements and will install them later today and report back.
I put the new rings on. I’m noticing that sometimes only 1 card will come out even though the game says 2 won.
Not a big deal since this is for home use
The flipper bat on my unit will often stay up after batting.
Any idea on what could be causing this?
Thanks
Quoted from SadSack:I just happened to take that entire assembly apart on mine today and the ball is hitting about twice as hard. Be sure to put some super lube on the main shaft that goes through to the top. Mine was a little gummy there. Mine was also missing one of the washers under one of the clips and that was also dragging it down a little. I bounced one off the corner and hit top glass today after it was done.
Played a full 9 inning game after using Super Lube. Didn’t stick once.
You're currently viewing posts by Pinsider cmjb13.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/slugfest-club-back-back-back-back%e2%80%a6-gone?tu=cmjb13 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.