Quoted from sulli10:Picked up a project SF a few days ago.
Got several problems solved, broken wires, burnt fuses, etc. Looking at a few problems, any direction would be appreciated.
1) is there a trick to pulling apart the control panel push buttons? Change up button bulb is burnt. Cannot get the switch apart to replace bulb?
2) none of the three home run OPTO's are working. Going to check the connect /resolder at the cpu board. Next step will be to replace the Opto board. Any other idea's
3) not sure if the magnet is working. Best methods to troubleshoot? I have a spare magnet core from another project.
On mine the buttons either twist to remove or just slightly angle to the side and pull.
I'd check the small opto board. You're sure it's connected properly?
You can go into diag test and it should pulse the magnet. Run a ball slowly over it and see if it changes the expected trajectory.
Im dealing with an issue where fast balls are more like curve balls lol. Pretty sure I need to pull the pitching mech apart and clean it