(Topic ID: 131866)
You're currently viewing posts by Pinsider pinballorphanage.
Click here to go back to viewing the entire thread.
Manitowoc, WI
2 weeks later
Quoted from swinks:skateball 2 looks nice
Thanks, there is a little misconception. I was able to find 2 machines that were in a condition to do this to. I was building the first one when the second one came along and knew how nice the first one was turning out!!
3 months later
Quoted from Tsskinne:Skateball lovers.... I come to you in great need.
Using quarantine to tackle my first playfield swap....and well let's just say attempting to pull an all-nighter and do this was a terrible idea to start with. If anyone has done a swap and can share your pictures of the underside I would be greatly appreciative.
If no one out there has done that, but you are willing to lift your playfield up and take me detailed pictures of the wireharness connections at the switches at the top of the playfield, basically everything above the 5-bank of drops on the playfield it would help me out a ton.
When I washed the harness i released too many zip ties and it turned my harness into a tangled mess that I'm working on solving. Thank you so much for any help. Pics can be emailed to [email protected] or just message me here and let me know how it would be best to get them from you.
Why did you take the harness apart? I leave all wires connected to switches and mechs and inspect the solder connections as i reinstall onto the new.
2 months later
5 months later
4 months later
Quoted from MVCO:Still looking to buy a nice Skateball!
Is this one nice enough for you???
tftc skateball 005 (resized).JPGtftc skateball 009 (resized).JPG 2 months later
Quoted from guitarded:Mid-Swap on my Skateball and am noticing that there are a few holes missing on the CPR PF. The Upper hole for the Orbit Rail is not there, nor id the hole for the post that protects it. Also, the Clear Post to the left of the Center (lower) Pop is not there...
Anyone got a few tips for drilling these? Never had to locate and drill holes on a new PF before. Thanks!
I'd back check the measurements of the holes in the original area with those around it and if they all are the same, mark where the hole should be and drill the hole.
5 months later
Quoted from gdonovan:Anyone have a scan of this plastic or the plastic itself for sale? Thanks.
[quoted image]
pm sent
1 month later
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider pinballorphanage.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
