"This is what is printed on the top of it
F6820
7813
SINGAPORE"
That is a 6820. The F stands for Fairchild the manufacturer
7813 is the year and week the chip was made.
SINGAPORE is where you go to get laid in asia.
You're currently viewing posts by Pinsider bigal56.
Click here to go back to viewing the entire thread.
"This is what is printed on the top of it
F6820
7813
SINGAPORE"
That is a 6820. The F stands for Fairchild the manufacturer
7813 is the year and week the chip was made.
SINGAPORE is where you go to get laid in asia.
The display has power so that is good. Take the display out and reflow all the solder connections. Could be a simple as a bad display enable connection.
Quench is correct about checking the resistors. Do you at least have the orange glow from the bottom of the display? That is from the keep alive. If that is dead you could have a bad panel.
The display is completely blank but has keep alive glow you are looking for a main component failure. I would suspect the U1 chip. However start with the basics paying close attention to pin 15 and 10 of the connector.
You're currently viewing posts by Pinsider bigal56.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/silverball-mania-new-member?tu=bigal56 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.