Has anyone used one of these to repair traces? Any luck with them? Thinking of giving it a try but a little leary on reliability

Cool thank you for the advise guys. I am going to do the jumper wires. Have 2 traces on a system 80b board. Do you guys recommend soldering to the trace or from start of the trace to the end point of it?

image.jpg

Yeah I jacked this up pretty good

Thank you for all the feedback guys. This will be socketed for the new style piggyback board from Great Plains. This is on the top side of the board and the bottom pads are fine. So since the top pads are trashed, could I just run the jumpers on the bottom?

That is a pretty cool set up. I noticed you still have the piggyback board on. Does that still have to be on the board?

Very cool. I was having booting problems with my piggyback board hence my crappy removal. I need to invest in a hakko so I can desolder properly