I purchased a set of Seigecrafts Williams drop target slider boards for my Blackout.
I installed the center (Condition Red) bank ones last night and my targets are not registering properly.
When the right 2 targets are down, it registers the entire bank and resets them.
I have double and triple checked my wiring as per the diagram (attached), and it is wired correctly.

Anybody else run into this with these boards or have any ideas?

TIA

AK-02-010 (resized).JPG

I forgot to add that I do have the boards themselves in the correct order as well.

Hans,

I will take a picture for you and upload it here.

I did not do the upper bank yet, so it still has original boards. Was wondering if this could be the issue.

Hans,

Picture as requested, let me know if you need more.

Thanks!

Center bank wiring (resized).jpg

I'd be willing to bet you found my issue Hans...

I never even noticed the difference in the 1 diode boards (jumper at the bottom of 1) until you responded and I looked at the schematics again.

I'd be willing to bet I have the jumper-ed board in the center, and not on the end.....I will let you know.

On a positive note, if it turns out to be this, I'm glad I spent the extra money for the connectors instead of soldering the wires direct to the board

DOH!!

Fixed and working...

Thanks for the help Hans

20160903_184227 (resized).jpg