Johnny;

Can you shoot a photo of that bank for me, how you have it wired? I wonder if there's something I missed when I came up with the schematic, many of them I only had access to the schematic manual and not an actual machine.

Does the other bank work ok?

-Hans

Wiring looks as per the schematic. I'll double check the switch matrix to make sure I have it correct.

Only thing I can't see is there's one more jumper on the boards, will be on one of the two targets that has a single diode.
Right above the wiring connector. It should be on the end target, not the center target.

All the diodes have the stripes the same? Away from the connector?

-Hans

I haven't had any contact with Steve in a while, unfortunately.

Getting a few e-mails today about Blackout drop targets, so I did an update to the diagram to answer the most common question.

-Hans

http://www.siegecraft.us/pinball/images/AK-02-010.JPG

I don't normally make them with the installed connectors, I don't know if the long term vibration will work the connectors loose or not. Just standard .156" headers, just like the ones one the CPU/Driver boards, except 8 pins instead of 9.

-Hans

Sorry on the late reply. They can be mixed, yes, but probably need some wiring changes depending on the game/location.

Which game and target is that?

-Hans

Almost looks like it’s missing the diode and jumper on the bird, any chance you can get a clearer picture of the board without the wires in the way?

Was the box correctly marked? I’d hate to have wrongly packaged things