That's the "trouble with tri-balls" I guess we need a multi-drill for Williams balls.
You're currently viewing posts by Pinsider BorgDog.
Click here to go back to viewing the entire thread.
I don't think necessarily what this thread had in mnd, but here is a router template I made to route the groove in shooter lane for my homebrew playfield. I used a 1" diameter round nose router bit for this, and the taper is set with the blocks on the bottom to match my 70s Gottlieb machines. simply clamped to the playfield and the bit set so it doesn't quite touch the playfield at the top end.
Quoted from mof:what him say? remove roll pin from plunger? need a pic...
-mof
I definitely thought for these for sure:
no pic but I use the same pipe insulation stuck on the top front edge of the backbox when I fold the head down so it rests on the side rails.
Nothing fancy, but finally got around to throwing together a bulb tester from scraps of wood and spare parts I had lying about. Put two of each style so I could compare bulbs after getting them mixed up, warm white vs cool vs sunlight etc.
PXL_20230402_184850470 (resized).jpgPXL_20230402_184945013 (resized).jpgYou're currently viewing posts by Pinsider BorgDog.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/show-and-tell-your-diy-homemade-tools?tu=BorgDog and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.